1. About
  2. Features
  3. Explore

I am the owner of a pretty Anycubic Mega I3 and it was very cool to own it.

However, now I have several problems when printing with it. It clicks all along, at high or low temperature, at 5 mm above the plate, and the result is very disgusting. It is the same with the basic black PLA, or with other PLA from ICE-Filaments but I can't do anything.

I use Cura and I've reset it several times, using the defaults options or not.

Here are two examples of some prints (normal cube):

example 1

First example of poorly printed cube

and Example 2

Second example of poorly printed cube

1 Answer 1

I had a similar issue after installing an E3D V6 using a Bowden extruder.

PLA needs a heat break that has a PTFE liner, since with all metal heat breaks, it's probable that the filament will reach glass transition temperature in the heat break and stop flowing properly.

Also, I had filament that was 1.86 mm instead of 1.75 mm, which caused it to bind inside the PTFE tube.

Before correcting these issues, I was able to temporarily fix the issue by doing a cold pull to unclog the extruder, and was able to print around 10 cm in height of a 20x20x20 mm cube.

To do a cold pull, heat your extruder between 80-100°C, and then pull out the filament. If successful, the tip of the filament will be shaped as the inside of the nozzle. If needed, heat the extruder to 200°C and manually push the filament to fill up the nozzle and heat brake, then let it cool down to the above temps and do the pull.