1. About
  2. Features
  3. Explore

I have a Folgertech Prusa i3, on a Ramps 1.4 with Marlin and I use Repetier-Host to control it. I am attempting to convert it to a dual extruder Bowden setup, and I can't seem to get the second extruder to work, although the first works just fine.

This is my problem:

I am not getting a reading in Repetier-Host for the thermistor of the second extruder. It is at a constant 100C. When I turn on the cartridge heater for the second extruder in Repetier-Host, the cartridge heater does not heat up.

This is what I have done:

For the second extruder, I connected the wires from the thermistor to the pins for T2 and the wires for the cartridge heater to D9. I have not updated anything in the Marlin firmware. In Repetier-Host, I selected that there are two extruders, and a second extruder is indicated under the 'manual controls' tab.

This is what I have double checked:

I confirmed the second thermistor works because it indicates a proper temperature reading when plugging it in both T0 and T1. I confirmed the second cartridge heater works because it heats up when connected to D10.

I apologize in advance if this is an amateur question, but I can't seem to find an answer anywhere. If somebody could at least point me in the right direction, or let me know if there is something I did not include in my post, I would really appreciate it, and hopefully it would help somebody else coming across a similar problem.

Thanks

1 Answer 1

Thanks to the comments, I was able to narrow down the specific issues in the firmware. The firmware version was really out of date, so I recommend finding the latest stable version.

Therefore, I found the latest stable version of Marlin, downloaded it, and created my own edited version. I went line by line in configuration.h and configuration_adv.h, with the old version I had side by side to the newer version, making any and all appropriate changes. Below are the lines I found most important to evaluate when setting up a second extruder.

Make sure the you have the right board selected from boards.h:

#define MOTHERBOARD 34 

Make sure the # of extruders is specified:

#define EXTRUDERS 2 

Make sure the sensor is active:

#define TEMP_SENSOR_0 6 #define TEMP_SENSOR_1 6 #define TEMP_SENSOR_2 0 #define TEMP_SENSOR_BED 6 

This should be considered:

#define HEATER_0_MAXTEMP 240 #define HEATER_1_MAXTEMP 240 #define HEATER_2_MAXTEMP 240 #define BED_MAXTEMP 90 

Everything under this comment should be looked at:

// Preheat Constants 

These would allocate the second extruder for other motors:

#define Z_DUAL_STEPPER_DRIVERS #define Y_DUAL_STEPPER_DRIVERS #define DUAL_X_CARRIAGE 

I'm sure there are other parameters I may have missed, and these are specific to my Prusa i3, but I hope this helps out anybody else in the future.