1. About
  2. Features
  3. Explore

I often have trouble with prints being especially difficult to remove from the build plate on my Micro3D printer. My wife suggested using a hair dryer on the underside of the plate. I was initially appalled at the idea, but now I think she may be on to something. Is this safe? Good idea? Bad idea? Heresay?

1 Answer 1

That was a problem for me too. My M3d printer was getting stuck to the plate. However, I now print on painters tape, and I put down painters take on the bed. Then I glue stick the tape, and when I am done, I just pull it up.

You should try it, because it will allow you to print with other then the m3d plastic.