1. About
  2. Features
  3. Explore

I'm using Repetier and Slic3r and it is printing a gap between the perimeter and infill on the first layer. Also, the infill is lifting (as in photo). Any advise?

infill issue

1 Answer 1

Okay, I found a solution that works for me.

I have increased my first layer extrusion width to 250%, reduced the print speed of perimeters to 30mm/s, reduced the brim width to 1 and increased the infill/perimeter overlap to 30%.

This was PLA with off heat bed, printing on glass and used hairspray ad adhesive. Most of my settings were on default. (Repetier & Slic3r).