NINT Knowledge Base
Is the weather a problem for MDF frames?
How is a J-Head Extruder Head attached to the Prusa i3 rework?
My endstops have 4 female plugs, but the examples on the RepRap Prusa i3 Site have 3; what are each of them for?
Is this fuse a good choice for my Prusa i3's power supply and RAMPS 1.4?
When building a RAMPS 1.4 based printer, can I safely plugin just some of the components to test if they are working?
Why does my MKS Base not recognize my thermisters?
Safely Hooking a Switch up to an OEM Power Supply?
Can I use a multimeter to test the outgoing voltage of this power supply?
How do I determine that the electronics are working with the test firmware?
Can I use a pin header in a breadboard to wire up the z-axis motors in parallel?
Connecting Sain Smart Mechanical End Stops to Ramps 1.4?
How do you make sure you have the right voltage on the trimpots on an A4988 stepper driver?
Frightened of Cheap Chinese Power Supply as I hook up the heated bed
What grade of wire is required for the heating element on a J-Head extruder?
Silver Solder specifications for hot end heating element