How do I wire the z-axis motors in parallel on the Prusa i3?

Printerbot printing stringy

z-axis hard to move in some areas - what could be faults, how to improve?

What's the advantage of two z motors?

Is there a reason for the z-axis M5 drive nut to be super loose on the lead screw?

Do I need to recalibrate z-probe offset every time I switch to a different layer height?

Printrbot simple metal not auto leveling

How to keep Z-axis motor from slipping when powered down

Print bed moves way up for printing

Z Axis getting stuck with Marlin 1.1.0-RC7

Is cutting the arm off the Z-axis switch a good idea?

Alignment of dual Z-axis steppers

Z-axis steppers and bed alignment problems

Is z-axis zero near the hotend?

Small Z axis step: Repetier-Firmware

Next Page